壓接另一端線芯。將接頭外護套管套在剝切短端—4電纜上，并在每相線芯上分別套E屏蔽銅絲網，再將短端電纜每相線芯導體分別插入已壓接在長端電纜每相線芯-9-～～的連接管內，進行壓接，除去飛邊和毛刺，用清潔布擦凈電纜絕緣表面、半導電層表面及導體連接管表面。
Crimp the core at the other end. The outer protective sleeve of the joint is sleeved on the stripped short end-4 cable, and the e-shielded copper wire mesh is sleeved on each phase core of the short end cable, and then the conductor of each phase core of the short end cable is respectively inserted into the connecting pipe crimped on each phase core-9 - ～ of the long end cable for crimping, the flash and burr are removed, and the insulation surface, semi-conductive layer surface and conductor connecting pipe surface of the cable are wiped with a clean cloth.
將接頭預制件移到接頭位置。在短端電纜絕緣表面上均勻地涂一層硅脂，然后將領套在長端電纜線芯上的接頭預制件拉到接頭位置，要保證預制件內兩端的應力錐半導電層正好分別搭蓋在兩端電纜絕緣外半導電層末端上，具體尺寸按制造廠提供的安裝說明書規定。
6. Move the joint preform to the joint position. Apply a layer of silicone grease evenly on the insulation surface of the short end cable, and then pull the joint preform sleeved on the long end cable core to the joint position. Ensure that the stress cone semi-conductive layers at both ends of the preform are just overlapped on the ends of the outer semi-conductive layers of the cable insulation at both ends, and the specific dimensions shall be in accordance with the installation instructions provided by the manufacturer.